8.SUSPENSION SYSTEM
8-
2
INSPECTION
Shock absorber
Inspect the shock absorber for oil leakage or damage,
inspect the bushing for wear or damage. If any damage
are found, replace the front shock absorber with a new
one.
Extend and compress the piston several times over its
entire stroke. Check that it moves smoothly and with
uniform resistance with rod up. Any of the following
conditions will denote a defective shock:
A skip or hang up when reversing stroke at
mid-travel.
Seizing or binding conditions except at extreme end
of either stroke.
A gurgling noise after completing
one full compression and extension
stroke.
Replace shock if any these conditions are
found.
Knuckle
Inspect the knuckle for damage. If any damages are found,
replace the knuckle with a new one.
Check ball joint for damage, pitting, looseness and
roughness. If so ,replace it.
Check ball joint bellows for cracks. Change if necessary.
Check bearing and seal for damage or wear, If any damages
or wear are found, replace a new one.
Rotate the inner race by hand to inspect
for abnormal noise and smooth rotation
Lower Suspension Arm
Inspect the suspension arm and for damage or distortion. If
any damages or distortion are found, replace the suspension
arm with a new one.
Summary of Contents for UTV1000-3
