6.DRIVE TRAIN
6-
8
Loosen the left rear wheel nut.
Install a jack stand under the frame to
lift the rear of vehicle off the ground
until the shock absorber is fully
extended.
Remove
the left rear wheel.
Remove the propeller shaft bolts on
engine side.
Remove propeller shaft bolts on rear differential
side.
Remove the rear propeller shaft
Inspection
Inspect the propeller shaft for wear or damage. If any defects are found, replace the propeller shaft with
new one.
Check if U-joint moves freely in all direction.
Check bellows for holes or brittleness.
Installation
Installation is the reverse of removal procedure.
Ensure tighten the bolts to the specified torque.
Installation location
Specifications (mm)
Torque N.m(kgf.m)
Bolt of rear propeller shaft flange
M10
80(8.2)
Summary of Contents for UTV1000-3
