4. COOLING SYSTEM
4-
8
Sharply strike water pump shaft out
with a plastic hammer.
Pull out water pump shaft through the
engine drive shaft opening.
NOTE:
Pay attention to hold thrust
washer to prevent it from falling in
crankcase.
1.
Thrust water here
CAUTION: If thrust washer is not on
water pump shaft, use a magnet to
retrieve it inside crankcase.
Using appropriate pliers remove and
discard the retaining ring securing
water pump gear on water pump shaft.
To remove plastic gear from water
pump shaft place gear between your
fingers and briskly tap shaft end.
Using 2 screwdrivers, pry out inner
part of the rotary seal.
Summary of Contents for UTV1000-3
