4. COOLING SYSTEM
4-5
Unplug the connectors of cooling fan.
Pull out upward the radiator from the lower mounting
holes on the frame, remove the radiator from the left side
of the vehicle.
Radiator inspection
Check radiating fins for clogging or damage.
Remove insects, mud or other obstructions with
compressed air or low pressure water.
Radiator installation
For installation, reverse the removal procedure.
Pay attention to the following detail.
Fill up the radiator.
Check for any coolant leakage from radiator and hoses.
COOLANT TANK
The coolant expands as the temperature (up to
100-11
0℃)
and pressure rise in the system. If the
limiting system working pressure cap is reached
110kPa, the pressure relief valve in the pressure cap is
lifted from its seat and allows coolant to flow through
the overflow hose into the overflow coolant tank.
Tank removal
Remove:
The upper cover of engine hood.
Coolant tank support bolt.
Overflow hose and clamp.
Tank installation
The installation is the reverse of the removal
procedure.
Refill coolant to upper level mark, it is about 650ml.
Connector of fan
Summary of Contents for UTV1000-3
