2.PERIODIC MAINTENANCE
2-
12
Clean the drain plug area.
Place an oil pan under the front reducer case,and
then drain oil completely by removing the drain
plug.
Tighten the drain plug to 20 N.m.
Pour the specified oil(GL-4-90) about 180mL by
syringe through the oil level check plug hole until
the oil over flows.
Tighten the oil level check plug to 20 N.m.
REAR DIFFERENTIAL OIL
To change the rear differential oil, locate the vehicle on
a level position and carry out the following steps.
Clean the oil level check plug area and remove the oil
level check plug.
Clean the drain plug area.
Place an oil pan under the front reducer case,and
then drain oil completely by removing the drain
plug.
Tighten the drain plug to 20 N
·
m.
Pour the specified oil(GL-4-90) about 220mL by
syringe through the oil level check plug hole until
the oil over flows.
Tighten the oil level check plug to 20 N
·
m.
STEERING SYSTEM
Park vehicle at flat ground and hold steering wheel for wobbling to up, down, left and
right.Check whether there is loosing. In case of wobbling, tighten nut or dismantle steering
column for further inspection.
Park vehicle at flat ground and turn handle left or right slowly to see whether it can be turned
flexibly. In case of obstacles, check whether it is caused by main cable or other wiring
installation. If it is not caused by above situations, please check the bottom of steering tie rod and
Drain Plug
Oil
level
check plug
Drain Plug
Summary of Contents for UTV1000-3
