3.ENGINE
3-
62
1. Crankshaft position sensor
2. Screw
4. Plug screw and discard sealing ring
1. Sealing ring
2. Plug screw
3. Crankcase PTO side, front side
Use a14 mm Allen key to turn crankshaft until
piston no. 2 is at TDC.
1. Allen key14 mm
When rear piston is at TDC marks on magneto
flywheel "2" and on the magneto cover are
aligned .
1. Mark
“
2
”
on magneto flywheel
2. Notch on magneto cover
3. Crankshaft position sensor location
Use a screwdriver to check if the groove in the
crankshaft is aligned with the hole.
1. Screw driver
Lock crankshaft
REQUIED TOOL
CRANKSHAFT LOCKING
1. Crankshaft locking bolt
Summary of Contents for UTV1000-3
