Liangzi Power UTV1000-3, Maintenance Manual

Page: 107 / 184

3. ENGINE
3- 79
1. Output shaft
2. 4
×
4 coupling sleeve
3. Soft hammer
Remove set screw, coupling fork shaft and
coupling fork from right cover.
1. Set screw
2. Coupling fork shaft
3. Coupling fork
Counter shaft
Use a soft hammer to push out counter shaft
from gearbox CVT side.
Remove distance sleeve and O-ring.
1. Counter shaft
2. Distance sleeve
3. O-ring
Gearbox Bearings
If necessary heat housing up to100°C(212°F)
before removing ball bearings.
NOTICE Always support gearbox housings
properly when ball bearings are removed.
Housing damages may occur if this procedure
is not performed correctly.
To remove ball bearings of counter shaft
(right cover) and main shaft (left cover) use
following tool .
For ball bearings of counter shaft (1eft cover)
and main shaft (center housing) push with a
suitable puller from outside in .
△
WARNING
Clean oil, outside and inside, from housing before
heating.
REQUIED TOOL
BLIND HILE BEARING