Liangzi Power UTV1000-3, Maintenance Manual

Page: 113 / 184

4. COOLING SYSTEM
4-1
4. COOLING SYSTEM
FAULT OVERHAULING ····························· 4-1 COOLING SYSTEM TEST ··························· 4-2
THERMOSTAT ········································· 4-3 RADIATOR AND CAP ································ 4-3
COOLANT TANK ······································ 4-5 RADIATOR FAN ········································ 4-6
WATER PUMP HOUSING ···························· 4-6 WATER PUMP IMPELLER ··························· 4-7
WATER PUMP SHAFT AND SEALS ··············· 4-7 WATER TEMPERATURE SENSOR ················· 4-11
Fault overhauling
1. If cover of radiator is open and temperature of cooling liquid is over 100
℃
, pressure of cooling liquid will
be reduced rapidly and boiled. Vapor injection may cause danger and injuries. After drop of temperature of
cooling liquid, use one cloth to cover the cover of radiator and then slowly open the cover. Cooling liquid
can only be tested after complete cooling.
2. Cooling liquid is toxic. Do not drink it or splash it to skin, eyes or clothes. In case of splashing cooling liquid
to your eyes, use clean water to wash your eyes completely and see the doctor. In case of splashing cooling
liquid to your clothes, use soapy water to wash it rapidly. In case of drinking cooling liquid, vomit will be
caused immediately. Please see the internist physician immediately. Store cooling liquid well and keep it out
of reach of children.
2. Check whether soil of fins is blocked or damaged. Correct curved fins. Use water and compressed air to
clean soil. If damaged area reaches 20%, please replace radiator.
3. Pump overhauling can be carried out before dismantling engine.
4. Only add cooling liquid to water tank in normal times. In addition to adding or exhausting cooling liquid,
please do not open cover of radiator.
5. Do not splash cooling liquid to plastic parts. Once splashed, please use clean water for washing.
6. After dismantling cooling system, check leakage situation of joint.
Sharp rise of water temperature
z Faults of radiator cover
z There is air in cooling system
z Faults of water pump
z Faults of thermostat (thermostat is not open)
z Blockage of radiator tube or cooling tube
z Damage or blockage to radiator
z Incomplete cooling liquid
z Failure or faults of fan motor
No rise or slow rise of water temperature.
Z Faults of thermostat (thermostat is not closed)
Z Faults of line of water temperature display
Leakage of cooling liquid
z Faults of water seal
z Aging, damage or improper sealing to O-shaped ring
z Aging, damage or improper sealing to gasket
z Improper installation of pipe or hose
z Aging, damage or improper sealing to pipe and/or hose
WARNING
！
Never start engine without coolant. Some engine parts such as the rotary seal on water pump shaft can be
damaged.