3.ENGINE
3-
56
NOTE: Wrong oil bore position will stop oil
supply to plain bearings and wil1 damage the
engine.
NOTICE
The partition of the plain bearings must
be positioned near to oil bore in counterclockwise
direction.
1. Partition
2. PTO cover (inside)
3. Oil bore
PTO Cover Installation
For installation, reverse the removal procedure.
Pay attention to the following details.
NOTE: At installation, replace PTO cover gasket
and oil seal.
Tighten PTO cover screws following the illustrated
sequence.
TIGHTENING SEQUENCE
PTO COVER SCREW
Tightening sequence
10N
·
m
士
1 N
·
m
(89lbf
·
in
士
9lbf
·
in)
DRIVEGEARS
Drive Gears Location
The engine is equipped with a breather gear which
prevents engine oil coming out through the
breathing system into the air intake system. The
drive gears are located on the engine PTO side
behind the PTO cover.
1. Breather gear
2. Intermediate gear
3. Water pump drive gear
4. Oil pump drive gear
Drive Gears Removal
Remove PTO cover (refer to PTO COVER).
Withdraw intermediate gear and breather gear.
For oil pump drive gear removal, refer to OIL
PUMP
in
the
LUERICATION
SYSTEM
subsection.
To remove water pump drive gear, pull the shaft
assembly a bit out and turn it about one teeth until
it stays out.
Then push water pump drive gear in.
Summary of Contents for UTV1000-3
