8.SUSPENSION SYSTEM
8-
3
Move suspension arm from side to side. There should be no noticeable loose. Replace bushing if
necessary.
Move suspension arm up and down.There should be no noticeable loose. Replace bushing if
necessary.
Upper Suspension Arm
Inspect the suspension arm and for damage or distortion. If
any damages or distortion are found, replace the
suspension arm with a new one.
Move suspension arm from side to side. There should be no
noticeable loose. Replace bushing if necessary.
Move suspension arm up and down.There should be no
noticeable loose. Replace bushing if
necessary.
Check ball joint for damage, pitting,
looseness and roughness. If so ,replace
it.
Check ball joint bellows for cracks.
Change if necessary.
REASSEMBLY
Reassemble and remount the front suspension in the reverse order of removal and disassembly.
Pay attention to the following points.
1. Install the washers and tighten the knuckle nuts to the specified torque.
2. Replace the removed cotter pins with new cotter pins.
Summary of Contents for UTV1000-3
