Liangzi Power UTV1000-3, Maintenance Manual

Page: 19 / 184

2.PERIODIC MAINTENANCE
2- 9
ENGINE OIL
Oil level verification
Strictly follow this procedure, otherwise
wrong oil level may be indicated.
1. Ensure vehicle is on a level surface.
2. Start engine and let idle for a few minutes.
3. Stop engine. Wait a few minutes to allow oil to
flow down to crankcase then check oil level.
4. Remove left and right seats, gear shift handle.
5. Remove engine shield
6. Remove dipstick and wipe clean
stem.
7. Fully screw in dipstick to check oil
level.
8. Remove dipstick and read oil level.
Oil level must be between
minimum(2) and maximum(1) marks
on dipstick.
9. There is a capacity of 300 ml between
the two marks. Refill oil as necessary.
Do not overfill.
10. Re-install dipstick.
Replace engine oil
Prior to change the oil, ensure vehicle is on a level surface. Oil and oil filter must be replaced at
the same time. Oil change and oil filter replacement should be done with a warm engine.
WARNING
The engine oil can be very hot. Wait until engine oil is warm.