Lanier AP4510, Setup Manual

Page: 315 / 424

Remote Maintenance by telnet
75
6
ROUTE
Use the route command to control the routing table.
This command allows you to configure and display routing information. You
can change the network configuration from remote PCs using this command.
Note
❒
The maximum number of routing tables are 16.
*1
IP address
SLP
Use this command to configure SLP settings.
You can search the NetWare server using SLP in the PureIP environment of
NetWare5/5.1. To use the slp command, you can configure the value of TTL
which can be used by the SLP multi-cast-packet.
Note
❒
The default value of TTL is “1”. A search is executed only within a local seg-
ment. If the router does not support multi-cast, the settings are not available
even if the TTL value is increased.
❒
The acceptable TTL value is 1 - 255.
msh> slp ttl {1 - 255}
Commands Topics of setting
route add {host | net} desti-
nation
*1
gateway
*1
Adds a host/network route to “destination”, and a gateway ad-
dress to “gateway” in the table. Host becomes the default setting.
route delete {host | net}
destination
*1
Deletes a host/network route from the table. Host becomes the
default setting.
route get {destination
*1
}
Displays only route information corresponding to a specified
destination. When the destination is unspecified, all routing in-
formation is displayed.
route active {host | net} des-
tination
*1
on/off
You can turn the specified destination on or off. Host becomes
the default setting.
route flush Deletes all routing information.