Lanier AP4510, Setup Manual

Page: 99 / 424

25
3. Paper and Other Media
Paper and Other Media Supported by This
Printer
Paper Sizes
This section describes the type, size, feed direction, and maximum amount of pa-
per that can be loaded into each paper tray in this printer.
Important
❒
If you use damp or curled paper, misfeeds might occur. In such a case, try
turning over the paper stack in the paper tray. If there is no improvement,
change to paper with less curl.
❒
Be sure to set the paper size dial to match the actual paper size loaded in the
tray. When the actual paper size is not shown on the dial, set the dial to “
p
”
and select the paper size using the control panel.
❒
For tray 1, 2, 3 and 4, the dial setting overrides settings selected with the con-
trol panel.
Note
❒
The following conventions are used to describe paper feed direction:
❒
It is recommended that you load paper having the size and direction you fre-
quently use in the tray selected with “Tray Priority”. For more information
about Tray Priority, see p.104 “Paper Input Menu”.
❒
When loading paper having the same size in more than one tray, it is recom-
mended that you load paper in the same direction.
❒
For more information about the meanings of symbols, see the notes at the bot-
tom of each table.
Reference
For more information about loading each type of paper, see p.33 “Loading Pa-
per and Other Media”.
Example on the panel display Paper feed direction
A4 (210
×
297) short-edge feed direction
A4 (297
×
210) long-edge feed direction