Lanier AP4510, Setup Manual

Page: 294 / 424

NetWare Configuration
54
4
EEEE
Click the IP address of the Network Interface Board which is to be config-
ured, and then click
[ Next > ] .
Note
❒
If you do not know which Network Interface Board you are configuring,
see the network configuration page to check the MAC address (Network
Address).
FFFF
Make sure that the MAC address and IP address are correct, and then click
[ Finish ] .
The [ NIB Setup Tool ] window appears.
GGGG
Click [ Configure ] .
The property sheet appears.
HHHH
Click the [ General ] tab, and then type the name of the print server into the
[ Device Name: ] box.
IIII
Click the [ NetWare ] tab, and then make the following settings.
A
A A
A
In the [ Print Server Name: ] box, type the name of the print server.
B B B B
In the [ File Server Name: ] box, type the name of the file server in which a
print server is to be created.
Clicking [ Browse ] , you can select a file server among those listed in the
[ Browse File Server ]
dialog box.
C C C C
In the [ NDS Context: ] box, type the context of the print server.
Clicking [ Browse ] , you can select an NDS tree and an NDS context among
those listed in the [ Browse Context ] dialog box.
As a context, object names are typed from a lower object and divided by a
period. For example, if you want to create a print server into NET under
DS, type “NET.DS”.
D
D D
D
In the
[ Print Server Operation Mode ]
group, click
[ As Print Server ]
.
E
E E
E
Click [ OK ] to close the property sheet.
F F F F
After the confirmation dialog box appears, click [ OK ] .
JJJJ
On the [ NIB ] menu, click [ Exit ] to exit the NIB Setup Tool.
After this step, go to step
K
on p.51 “Setting Up as a Print Server”.