Lanier AP4510, Setup Manual

Page: 267 / 424

Configuring the Protocols
27
3
Configuring the Protocols
Configuring TCP/IP and IPP for Printing
These instructions are for configuring the Network Interface Board and Win-
dows NT to use the TCP/IP protocol and IPP.
Configuring the machine
Configure the machine to use the TCP/IP protocol.
• Make sure that the TCP/IP protocol is set to active. (The default is active.)
• Assign an IP address and make other settings required for using the TCP/IP
protocol.
Reference
For more information about how to make the above settings, see the Setup
Guide.
If DHCP is used to assign IP addresses, see p.92 “Using DHCP”.
Note
❒
After setting the IP address, use the ping command to make sure that it has
been correctly set.
A
Click [ Start ] , point to [ Programs ] , and then click [ Command Prompt ] .
B
Type the following: (Example IP address is 192.168.15.16)
C:\> ping 192.168.15.16
If the address has been configured correctly, the following message ap-
pears.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message ap-
pears.
Request timed out.
Configuring a Windows NT computer
These steps are for configuring a Windows NT computer to use the TCP/IP pro-
tocol.
AAAA
Open
[ Control Panel ]
, and then double-click the
[ Network ]
icon. Make sure
that “TCP/IP Protocol” is listed in the [ Network protocols ] box on the [ Proto-
cols ] tab.
Note
❒
If the TCP/IP protocol is not installed, click [ Add ] on the [ Protocols ] tab to
install it. For more information about installing the TCP/IP protocol, see
Windows NT Help.