Lanier AP4510, Setup Manual

Page: 103 / 424

Paper and Other Media Supported by This Printer
29
3
Paper Recommendations
Loading Paper
Important
❒
Do not use paper that is meant for an ink-jet printer, or it may stick to the fus-
ing unit and cause a paper misfeed.
❒
When printing on an OHP transparency that has a print side, be sure to print
on the print side. Otherwise, it may stick to the fusing unit and cause a paper
misfeed.
❒
Set the paper as described below:
• Standard Tray/Optional Paper Bank: Print side facing up
• Large Capacity Tray: Print side facing down
• Bypass Tray: Print side facing down
❒
Print quality cannot be guaranteed if paper other than the ones recommended
is used. For more information about recommended paper, contact your sales
or service representative.
❒
Do not use paper that has already been printed on by other printers.
Storing Paper
• Paper should always be stored properly. Improperly stored paper might re-
sult in poor print quality, paper misfeeds, or printer damage. Recommenda-
tions are as follows:
• Avoid storing paper in humid areas.
• Avoid exposing paper to direct sunlight.
• Store on a flat surface.
• Keep paper in the package in which the paper came.
Types of Paper and Other Media
❖ ❖ ❖ ❖
Plain Paper
• Plain paper here means paper up to 105 g/m
2
(28 lb. bond).
• Any input tray can be used.
• A standard tray can hold up to 500 sheets per tray and 1000 sheets in total.
The optional Paper Bank can hold up to 500 sheets per tray and 1000 sheets
in total.
The Large Capacity Tray can hold up to 1,500 sheets.
The Bypass Tray can hold up to 50 sheets.
Confirm that the top of the stack is not higher than the limit mark inside
the tray.