Lanier AP4510, Setup Manual

Page: 113 / 424

Loading Paper and Other Media
39
3
Loading Paper in the Bypass
Tray
Note
❒
Paper sizes supported by the By-
pass Tray are approximately 100 -
297 mm (3.94 - 11.69 inches) in
width, and approximately 148 -
432 mm (5.83 - 17 inches) in length.
❒
Specify a custom size with the con-
trol panel. For more information
about using the control panel, see
p.41 “Specifying a Custom Paper
Size for the Bypass Tray”.
❒
If you load thick paper, OHP trans-
parencies or envelopes, make the
setting for each paper type with
the control panel or the printer
driver. See p.104 “Paper Input
Menu”.
❒
The number of pages that can be
loaded in the Bypass Tray differs
depending on the paper type. Con-
firm that the top of the stack is not
higher than the limit mark inside
the tray.
Reference
For more information on the size
and feed direction of paper that
can be set in the tray, see p.25 “Pa-
per Sizes”.
Limitation
❒
The following functions are not
available with the Bypass Tray:
• Duplex print
• Limitless paper feed
• Output from the Finisher (sta-
ple, punch)
AAAA
Open the Bypass Tray.
Note
❒
Swing out the extender (
A
) to
support paper sizes larger than
A4/letter
L
.
BBBB
Slide the paper guides outwards,
and then load paper until it stops
with the print side down.
Important
❒
Confirm that the top of the stack
is not higher than the limit mark
inside the tray.
❒
Shuffle the paper before loading
the stack onto the tray so multi-
ple sheets are not fed in at one
time.