Lanier AP4510, Setup Manual

Page: 141 / 424

Error & Status Messages on the Control Panel
67
5
Getting Printer Information over the Network
Printer current status
You can check the printer's status using the telnet command.
❖
❖ ❖
❖
telnet
Use the stat command.
❖ ❖ ❖ ❖
UNIX
Use the lpq or lpstat command or stat parameter of rsh, rcp, or ftp.
Reference
For more information, see “ Remote Maintenance by telnet ” in the Network
Printing Guide on the CD-ROM labeled “Operating Instructions”.
Messages Description Solution
Call Service Center: SC An error has occurred in the
printer. First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
Cover Open: Bridge The cover of the Bridge Unit is
open. Close the cover.
Cover Open: Duplex Unit The cover of the optional Du-
plex Unit is open. Close the cover of the optional
Duplex Unit.
Close Open: Finisher The cover of the Finisher
SR730 is open. Close the cover.
Cover Open: Front Cover The front cover of the printer
is open. Close the front cover.
Cover Open: Lower Right
Cover The lower vertical paper feed
cover is open. Close the cover.
Cover Open: Mailbox The cover of the Mailbox is
open. Close the cover.
Cover open: Right Cover The upper vertical paper feed
cover is open. Close the cover.
Empty: Toner The printer is out of toner. Replace with a new toner bot-
tle.
Energy Saver Mode The printer is in Energy Saver
Mode. No action is required.
Error: DIMM An error has occurred in the
printer. First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
Error: Ethernet An error has occurred in the
Ethernet Board. First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.