Lanier AP4510, Setup Manual

Page: 255 / 424

Configuring the Protocols
15
2
Configuring the Protocols
Configuring TCP/IP and IPP for Printing
Follow these instructions to configure the Network Interface Board and Win-
dows 2000 to use the TCP/IP protocol and IPP.
Configuring the machine
Configure the machine to use the TCP/IP protocol.
• Make sure that the TCP/IP protocol is set to active. (The default is active.)
• Assign an IP address and make other settings required for using the TCP/IP
protocol.
Reference
For more information about how to make the above settings, see the Setup
Guide.
If DHCP is used to assign IP addresses, see p.92 “Using DHCP”.
Note
❒
After setting the IP address, use the ping command to make sure that it has
been set correctly.
A
Click [ Start ] , point to [ Programs ] , point to [ Accessories ] , and then click [ Com-
mand Prompt ] .
B
Type the following: (Example IP address is 192.168.15.16)
C:\> ping 192.168.15.16
If the address has been configured correctly, the following message ap-
pears.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message ap-
pears.
Request timed out.
Configuring a Windows 2000 computer
Follow these steps to configure a Windows 2000 computer to use the TCP/IP
protocol.
AAAA
Click [ Start ] on the taskbar, point to [ Settings ] , and then click [ Network and
Dial-up Connections ] .
BBBB
Click
[ Local Area Connection ]
. On the
[ General ]
tab, click
[ Properties ]
.