Lanier AP4510, Setup Manual

Page: 275 / 424

Configuring LPR Port Printing
35
3
Configuring LPR Port Printing
This section explains the procedure for printing to a LPR port from Windows
NT.
Note
❒
The following procedure assumes that the printer drivers have already been
installed. This is the procedure to change the printer port to LPR.
❒
The TCP/IP protocols must be installed and configured correctly. For more
information about configuring the protocol, see p.27 “Configuring TCP/IP
and IPP for Printing”.
AAAA
Click [ Start ] , point to [ Settings ] , and then click [ Printers ] .
BBBB
Click the icon of the printer you want to use. On the [ File ] menu, click [ Prop-
erties ] .
CCCC
Click the [ Ports ] tab, and then click [ Add Port ] .
DDDD
In the [ Available Printer Ports ] box, click “LPR Port”, and then click [ New Port ] .
Note
❒
If “LPR Port” does not appear, “Microsoft TCP/IP Printing” has not been
installed.
EEEE
Type the IP address of the Network Interface Board into the [ Name or address
of server providing lpd ] box.
FFFF
Type “lp” into the
[ Name of printer or print queue on that server ]
box, and then
click [ OK ] .
GGGG
Click [ Close ] .
HHHH
Make sure that the port name is displayed in the [ Print to the following port(s) ]
box and the check box is selected, and then click [ OK ] .