LaCie 131018 - StorView Snapshot - Mac, User Manual

Page: 168 / 214

StorView RAID Module
160
SATA Multiplexer switching
failure on Enclosure <
name >
Slot < nn >.
Error
[0xB13 (2835)] This indicates that the
controller has tried
multiple times to switch
the Multiplexer (MUX) on
a SATA drive and it has
not been successful.
This may be due to a bad
drive or MUX Transition
card (dongle). Replace the disk drive
or MUX Transition Board
(dongle).
Array < name > is in a critical
state.
Error
[0xB1B (2843)] Drive removal or failure. Replace the disk drive
and rebuild the array.
The drive w/SN < xxxxxxx >
(Slot < number >) returned a
bad status while completing a
command. SCSI Info:
Operation <
type >, Status
< type >.
Warning
[0xB27 (2855)] Unknown status returned
by the disk drive. Contact technical support
and provide them with a
copy of the event log.
The drive w/SN < xxxxxxx >
(Slot < nn >, Enclosure < nn >)
timed out for the SCSI
Operation <
type >.
Warning
[0xB28 (2856)] Drive hardware error or
bus error. Check cabling and
ensure the disk drives are
properly seated.
A rebuild has started on the
drive w/SN <
xxxxxxx > (Slot
< nn > (Drive < number >).
Information
[0xB30 (2864)] A rebuild has started. No action necessary.
A rebuild has completed on
(Array <
Name > Drive
< number >).
Information
[0xB31 (2865)] A rebuild has completed. No action necessary.
A rebuild has re-started on the
drive w/SN <
xxxxxxx > (Slot
< nn > (Drive < number >).
Information
[0xB32 (2866)] A rebuild has started. No action necessary.
Array < name> has started
initializing.
Information
[0xB33 (2867)] Initialization has started. No action necessary.
Array < name> has completed
initializing.
Information
[0xB34 (2868)] Initialization has
completed. No action necessary.
A SAS command was aborted
on the drive w/WWN
<xxxxxxxxxxxxxxxx> (Slot
<
num >, Enclosure < num >) for
the SCSI Op Code ( hex string ).
Warning
[0xB39 (2873)] Aborted command. Possible reasons are:
faulty disk drive, faulty
drive slot, fault enclosure,
cable issue, faulty drive
firmware, fault in SAS
expander, excessive
noise, or possible drive
interference.
Drive & Array Event
Messages Type [ID] Cause Action