StorView RAID Module
96
9.2.3 Host Ports
9.2.3.1
F5404E RAID Controller Systems
In the Host Ports section, you can change the LUN (ID) assigned to each of the controller ports, set the
type of connection, and set the data rate.
• Controller Port ID (P0) - This is the target ID for both controller(s) port 0. It can range from: Soft
Address, or 0 - 125. The default is ID 4.
• Controller Port ID (P1) - This is the target ID for both controller(s) port 1. It can range from: Soft
address, or 0 - 125. The default is ID 5.
Note:
The ports are identified in the software as P0 and P1, they refer to the label on the RAID
Controller which indicates FC Host 1 and FC Host 2 connectors respectively. Controller 0
refers to the left controller and Controller 1 is the right controller.
• Controller Port Data Rate - Use the Automatic setting for most configurations. If you choose to use
a specific setting (1 Gb, 2 Gb, or 4 Gb) you override the automatic setting. Be sure the software
setting here matches the hardware switch setting on the HBA ports.
Note:
When using an Active-Active configuration (dual controllers) set the Controller Port Data
Rate to a predetermined speed. When the Automatic setting is used with Active-Active it is
possible for the speed to step down to 1Gb during a fail-back operation. For 2 Gb or 4 Gb
operations, manually setting the speed will prevent this from happening.
Figure 9–5
Advanced Settings Window - F5404E
Summary of Contents for 131018 - StorView Snapshot - Mac
