LaCie 131018 - StorView Snapshot - Mac, User Manual

Page: 163 / 214

Event Logs
155
An SDRAM ECC error - bit
<
xx > at address
< xx,xx,xx,xx . xx > has been
detected and corrected.
Warning
[0xB72 (2930)] SDRAM error. If it repeats, replace the
controller.
A configuration parameter has
been changed: <
array name >
(Array < number >) has been
trusted due to a cancellation of
an initialization.
Information
[0xB74 (2932)] A user cancelled an
initialization. No action necessary.
Hardware Error
Additional Info: ( Advanced hex
data for customer service reps
or engineer use. ).
Error
[0xB7A (2938)] The controller will
continue to function,
however the SES
temperature sensing may
not function properly. Replace the controller.
Running < version_number >
CEMI firmware version:
Release <
num >, Build < num >.
Information
[0xB89 (2953)] CEMI firmware is current. No action necessary.
“Automatic” or “Manual” CEMI
firmware upgrade from
<
original CEMI FW version >:
Release < num >, Build < num >
to new version: Release
<
num >, Build < num >
< completed successfully>, <i s
underway >, or < failed >.
“Automatic” or “Manual”,
depending on whether the
upgrade attempt was
automatic or manual.
Error
[0xB89 (2953)] Firmware is attempting to
upgrade. No action necessary.
CEMI firmware upgrade from
<
original CEMI FW version >:
Release < num >, Build < num >
to new version: Release
<
num >, Build < num > failed
because there is no response
from the processor.
Error
[0xB89 (2953)] Firmware failed to
upgrade due to non-
responding controller. No action necessary.
Occurs when there is a remote
request to restart Embedded
module.
A remote request for a
Embedded module reset was
successful.
Information
[0xB8A (2954)]
Embedded module reset
was successful. No action necessary.
Controller Events Messages Type [ID] Cause Action