IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 515 / 605

Table 28. Intervention-Required Conditions (continued)
Intervention-Required Condition Resolution Actions
Message OP0124
Stacked volume xxxxxx is unavailable with a reason
code of yyyyy. (VTS z)
Probable Cause
During a recall operation, the stacked volume was not
found in the library where expected.
During the reclamation process, a stacked volume was
made unavailable. The volume is placed subsequently in
read-only status. The reason code values and
descriptions are listed below.
Reason Code
Description
0 The stacked volume was not found where
expected during a recall.
1039 The volume was made read-only because it was
a filling volume after a disaster recovery.
1056
The volume was made read-only due to
permanent read errors on remaining logical
volumes after all readable data has been
recovered
1068 The volume was made read-only for an
unknown reason. The volume is unavailable,
either permanently or temporarily because of
drive load/unload failure
1069 The volume was made read-only because a
database backup is missing on this tape.
1087 The volume was made read-only due to I/O
errors.
For a reason code other than 0, this message should be
considered informational because the subsequent
processing of read-only status volumes may result in
transparent recovery. You should call your service
representative only when recovery of a logical volume is
necessary after having received the message Logical
volume xxxxxx was not fully recovered from damaged stacked
volume yyyyyy. (VTS z) .
Message OP0125
VTS controller degraded. Error code yyyyy. Call service.
(VTS z)
Probable Cause
A VTS redundant component has failed. Operation of the
VTS is continuing.
Note: The error code is not useful to the operator;
however, the service representative can use the error
code to help determine the cause of the failure.
1. Record the error code, yyyyy.
2. Call your service representative.
Chapter 8. Problem Determination Procedures
489