IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 470 / 605

Table 25. DFSMS Messages Based on Library Failure or Exception Conditions (continued)
Resulting Console Message Action
CBR3724I Volume volser does not exist in library
library-name .
Volume volser does not reside in 3494 library-name . It is
possible that another host system has ejected the volume
from the 3494 Tape Library.
1. Use the ISMF mountable tape volume list function to
examine the current state of the volume under
DFSMS.
2. Determine where the volume is and reenter it into the
library’s input station.
CBR3725I Library library-name command reject for
volume volser . Library error code= error-code .
Library library-name has rejected a request for a 3494
Tape Library operation with volume volser . The error
code indicates the reason for the rejection but is included
for diagnostic purposes only.
It is likely that the microcode in the 3494 Tape Library
and the software are not at the correct level.
Notify your system administrator.
CBR3726I Function incompatible error code error-code
from library library-name for volume volser .
The library cannot process a request for a 3494 Tape
Library operation with volume volser because the request
is incompatible with the configuration or set of installed
features of the 3494 Tape Library.
If error-code=6 , an attempt was made to eject a logical
volume from a VTS.
If error-code=7 or 8 , a command for an Export or Import
operation was issued to a VTS partition that is not
capable of Export and Import operations.
If error-code=D , an attempt was made to either eject or
audit a logical volume in a PtP VTS, and the subsystem
is in the Service Preparation mode.
If error-code=E , one of the following occurred:
v
An attempt was made to eject a logical volume in a
PtP VTS, and the subsystem already has 1,000 eject
operations in progress.
v
An attempt was made to audit a logical volume in a
PtP VTS, and the subsystem already has 1,000 audit
operations in progress.
If error-code=F , a command that specified a parameter
value that the subsystem does not support was issued to
a PtP VTS.
If error-code=10 , a category mount request or a set
volume category request was issued to a PtP VTS, and
the subsystem was in read-only mode.
It is also possible that the microcode in the 3494 Tape
Library and the software are not at the correct level.
Notify your system administrator.
444
3494 Tape Library Operator Guide