IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 386 / 605

Note: HRMCNFIG is a process external to the Library Manager, and therefore, you
must wait until that process has completed before Library Manager’s SNMP
support is enabled. To do this, wait until the Change SNMP trap
destinations becomes available again. When it is available, you can use all
SNMP features.
Adding a Destination:
Perform the following steps to add an SNMP trap destination:
1. When the HRMCNFIG program is running, select the trap destination radio
button. The Network Mask input field is then unavailable. (SNMP trap
messages do not need to use this option.)
2. Select UDP in the Protocol field, enter the monitor station name and address in
the appropriate fields, then select the Add push button. Do this for each of the
monitor stations.
3.
Select the
OK
push button when done.
Deleting a Destination:
Perform the following steps to delete an SNMP trap destination:
1.
In the list box, highlight the SNMP trap destination that you want to delete.
2. Select the Delete push button.
3. Select the OK push button when done.
Starting SNMP:
When you have selected the trap types and configured the SNMP trap
destinations, you must enable the Library Manager SNMP support. To do this,
select the
Start SNMP
option in the SNMP Options window.
Selecting this option starts the SNMP daemon. To ensure that the daemon is
running, press Ctrl + Esc to bring up a window list and ensure that SNMPD is
listed.
Figure 233. SNMP Configuration Window
360
3494 Tape Library Operator Guide