IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 488 / 605

Table 28. Intervention-Required Conditions (continued)
Intervention-Required Condition Resolution Actions
Message OP0011
A duplicate volser (xxxxxx) was left in high-capacity
input rack cell yyyy.
Probable Cause
During an Insert operation, a cartridge whose external
volume serial number, xxxxxx, is the same as that of
another cartridge in the 3494 Tape Library was found in
high-capacity facility cell yyyy. The 3494 Tape Library
does not support more than one cartridge with the same
volume serial number.
1. Place the 3494 Tape Library in Pause mode.
2. Open the appropriate enclosure door.
3. Remove the cartridge from the high-capacity facility.
4. Determine why the cartridge is a duplicate and take
corrective action.
5. Close the enclosure door.
6. Place the 3494 Tape Library in Auto mode.
Message OP0012
An unreadable volser was left in high-capacity input
rack cell yyyy.
Probable Cause
During an Insert operation for the high-capacity facility,
the vision system was not able to read the external
volume serial number label on the cartridge. The
problem cartridge is in cell yyyy. The label may not have
been installed correctly, is damaged, or is not one of the
supported label types.
1. Place the 3494 Tape Library in Pause mode.
2. Open the appropriate enclosure door.
3. Remove the cartridge from the high-capacity facility.
4. Close the enclosure door.
5. Place the 3494 Tape Library in Auto mode.
6. Replace the unreadable label with a readable label.
7. Place the cartridge in the convenience I/O station.
Message OP0013
An invalid volser (xxxxxx) was left in high-capacity
input rack cell yyyy.
Probable Cause
During an Insert operation for the high-capacity facility,
the vision system read the external volume serial number
label on the cartridge, and it contained one or more
invalid characters. The label must not contain leading or
imbedded blanks or characters other than upper case
A–Z and numerics 0–9. The problem cartridge is in cell
yyyy.
1. Place the 3494 Tape Library in Pause mode.
2. Open the appropriate enclosure door.
3. Remove the cartridge from the high-capacity facility.
4. Close the enclosure door.
5. Place the 3494 Tape Library in Auto mode.
6. Determine why the cartridge is invalid and take
corrective action. Invalid volsers contain leading or
imbedded blanks or invalid characters. Valid
characters are upper case A–Z and numerics 0–9.
Message OP0014
An invalid volser (xxxxxx) was left in the convenience
I/O station.
Probable Cause
During an Insert operation, the vision system read the
external volume serial number label on the cartridge, and
it contained one or more invalid characters. The label
must not contain leading or imbedded blanks or
characters other than upper case A–Z and numerics 0–9.
1. Remove the cartridge from the convenience I/O
station.
2. Determine why the cartridge is invalid and take
corrective action. Invalid volsers contain leading or
imbedded blanks or invalid characters. Valid
characters are upper case A–Z and numerics 0–9.
462
3494 Tape Library Operator Guide