IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 237 / 605

v JX-EWTCL (Non-VTS xxxxx)
v
1 - CST (VTS 1 xxxxx)
v E - ECCST (VTS 1 xxxxx)
v
J - HPCT (VTS 1 xxxxx)
v K - EHPCT (VTS 1 xxxxx)
v
JA-ETC (VTS 1 xxxxx)
v JB-ETCL (VTS 1 xxxxx)
Note: Media type JB is not supported with VTS
v JJ-EETC (VTS 1 xxxxx)
v
1 - CST (VTS 2 xxxxx)
v E - ECCST (VTS 2 xxxxx)
v
J - HPCT (VTS 2 xxxxx)
v K - EHPCT (VTS 2 xxxxx)
v
JA-ETC (VTS 2 xxxxx)
v JB-ETCL (VTS 2 xxxxx)
Note: Media type JB is not supported with VTS
v
JJ-EETC (VTS 2xxxxx)
Specific Category
Select this check box if the list output should include only volumes with a
specific category. Use the associated entry field to enter the desired
category. The category must be entered as a four-digit hexadecimal
number.
Volume Mask
Select this check box if the list output should include only volumes that
match the volume mask. Use the associated entry field to enter the one- to
six-character volume mask. A wild card (pattern-matching) character can
be included where ? or _ indicates one character and * or % indicates
multiple characters.
Encryption Status
Select this check box if the list output should only include volumes with a
specific encryption status. Use the associated entry field to enter the
encryption status to search for.
Flags Select the desired flag buttons if the list should include only volumes with
certain flags set or cleared. Each flag can be set to one of three possible
settings by clicking the associated button.
The flags can be one of the following options:
v Yes
The flag’s condition applies to this volume (list volumes to which this
flag applies).
v No
The flag’s condition does not apply to this volume (list volumes to
which this flag does not apply).
v
Ignore
List volumes with the flags set to any value (list volumes without regard
to the state of the flag).
You can select the following flags:
Chapter 6. Advanced Operating Procedures
211