IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 496 / 605

Table 28. Intervention-Required Conditions (continued)
Intervention-Required Condition Resolution Actions
Message OP0041
The cartridge label located at cell yyyy is invalid.
Probable Cause
During an Inventory or Inventory Update operation, the
vision system read the external volume serial number
label on the cartridge, and it contained one or more
invalid characters. The label must not contain leading or
imbedded blanks or characters other than upper case
A–Z and numerics 0–9. The problem cartridge is in cell
yyyy. A convenience I/O station is either not installed, is
full, or is unavailable, and a high-capacity output station
has not been defined.
1. Place the 3494 Tape Library in Pause mode.
2. Open the appropriate enclosure door.
3. Remove the cartridge from the rack cell position
yyyy.
4. Close the enclosure door.
5. Place the 3494 Tape Library in Auto mode.
6. Determine why the cartridge label is invalid and take
corrective action.
7.
Reinsert the cartridge into the 3494 Tape Library
through available facilities.
Message OP0042
The system has failed. A service call is required.
Probable Cause
A major failure of the systems in the 3494 Tape Library
has occurred.
Call your service representative.
Message OP0043
* The accessor or gripper configuration has changed.
The 3494 must be retaught.
Probable Cause
The second gripper has either been installed or removed
from the library, but the 3494 Tape Library has not been
retaught. Damage to the 3494 Tape Library can result if it
is not retaught.
1.
Call your service representative.
2.
The 3494 Tape Library must be put in Service mode
and retaught to show the current gripper
configuration.
3. This condition cannot be cleared by selecting it from
the list of actions. Instead, the 3494 Tape Library
clears this condition automatically when it is
retaught.
Message OP0044
* The top two I/O station cells are inaccessible. Move
cartridges to cell 3.
Probable Cause
In a 3494 Tape Library that is configured with dual
grippers, Gripper 1 has failed, and cartridges were
placed in the top two cells of the I/O station. The top
two cells of the convenience I/O station are no longer
usable until Gripper 1 is repaired.
1. Open the convenience I/O station.
2. Remove the cartridges from the top two cells of the
I/O station.
3. Replace the cartridges in the I/O station using cell 3
or below.
4. Close the convenience I/O station.
5. This condition cannot be cleared by selecting it from
the list of actions. Instead, the 3494 Tape Library
clears this condition automatically when the
cartridges are removed from the top two convenience
I/O station cells and the I/O station is closed.
470
3494 Tape Library Operator Guide