IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 478 / 605

Table 25. DFSMS Messages Based on Library Failure or Exception Conditions (continued)
Resulting Console Message Action
CBR3787E Immediate mode copy operations deferred in
library library-name .
PtP VTS library-name is configured in the Immediate
Copy mode, and one or more copies could not be
completed before presenting ending status for a
rewind/unload command. Possible causes are:
v Copy operations have become disabled.
v A copy operation was taking more than the time
allowed by the Virtual Tape Controller (40 minutes).
The copy will complete independently of the
presentation of ending status for the rewind/unload
command. This message will be deleted when the
copy completes.
If CBR3785E is also presented, call your service
representative. If not, then it is likely that the workload
on the subsystem is high, and copies will be completed
automatically.
CBR3788E Service preparation occurring in library
library-name .
One of the VTSs in PtP VTS library-name is either being
prepared for service or is being serviced. Operations of
the PtP VTS will be degraded.
No action is required. When the service representative
has completed service on the VTS, normal operations
will resume, and this message will be deleted.
CBR3789E VTS library library-name is out of empty
stacked volumes.
Library library-name has no scratch stacked volumes.
When this occurs and the library is not a distributed
library (meaning that it is not part of a PtP VTS), mount
operations can no longer be performed until additional
scratch stacked volumes are available. If the 3494 Tape
Library is one of the distributed libraries of a PtP VTS,
most mounts will continue being performed using the
resources of the other distributed 3494 Tape Library.
Mounts that fail result in a CBR4196D message and
should be retried to use the resources of the other
distributed library.
If the 3494 Tape Library is not a distributed library, add
additional physical volumes to the library.
If the 3494 Tape Library is a distributed library:
v
Add additional physical volumes to the library.
v
Reply retry to any CBR4196D messages.
CBR3790E VTS library library-name has insufficient
resources to continue mount processing.
Library library-name does not have the resources to
continue processing mounts. A possible cause is that the
VTS has determined that it does not have at least two
available physical devices. When this occurs and the
library is not a distributed library (meaning that it is not
part of a PtP VTS), mount operations can no longer be
performed until the missing resources are available. If
the 3494 Tape Library is one of the distributed libraries
of a PtP VTS, most mounts will continue being
performed using the resources of the other distributed
library. Mounts that are failed will result in a CBR4196D
message and should be retried to use the resources of the
other distributed library.
If the 3494 Tape Library is not a distributed library, call
your service representative.
If the 3494 Tape Library is a distributed library:
v
Reply retry to any CBR4196D messages.
v
Call your service representative.
452
3494 Tape Library Operator Guide