IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 419 / 605

3. Remove the cartridge from the enclosure and place it in a safe location. Be sure
to remove all ejected cartridges from the enclosure when you complete Manual
mode operations.
4.
Confirm that the eject operation is complete by performing the following steps:
a. On the Library Manager Action List, highlight the action item you want to
confirm.
To highlight an item, use the up arrow (
↑
) or down arrow (
↓
) key to move
the highlight bar to the desired action item.
b. To confirm the highlighted action item, press the Enter key.
Note:
Be sure to confirm each ejected cartridge after completing the eject task.
Eject actions remain on the Action List until you confirm them manually.
5. Press the Refresh key ( F9 ) to update the list.
Reviewing Unknown Volume Locations
Use this procedure if you are not sure where a volume should go. Youcan display
the volser From location and To location of the last 20 completed actions. Perform
the following steps and use this information to verify the accuracy of a completed
action item:
1. Press the Review key ( F6 ) on the Library Manager Action List (Figure 242 on
page 387).
2.
Press
F12
to return to the Action List.
If the Manual Mode Review List (Figure 244) did not list the volume, use the
Locate Cartridge Home window (Figure 246 on page 395) to find a storage cell to
put the volume in.
Note:
The operator pressing F4 on the Action List caused the ERROR indication.
You can only view this list. You perform the tasks (actions) from the Action List.
Review List
Action VOLSER From To
Mount GKT333 Rack 2 B 40 Device 200 Confirmed
Eject SRJ485 Rack 1 A 7 Confirmed
Mount EPF371 Device 200 Device 3E1 Confirmed
Mount SDR495 Rack 7 A 6 Device 201 ERROR (see Note)
F1=Help F3=HideScreen F12=Cancel
Figure 244. Manual Mode Review List Window
Chapter 6. Advanced Operating Procedures
393