IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 560 / 605

Table 51. Status Codes and Status Text (continued)
Operation Status Resolution Actions
Status Code
32
Status Text
Invalid container volume
Probable Cause
For Export operations, a cancel that an operator
issued from the Library Manager console or a
termination because of host inactivity may have
resulted in a ‘container volume’ being shown in
the tape management system database for
logical volumes that have not been exported
from the VTS.
For each logical volume having this status code, the tape
management system data base must be searched and
corrected if a ‘container volume’ is shown.
For DFSMSrmm
™
, the following steps may be taken:
1. Using the volser of the first volume in the Status File
with status code X'32', perform an
RMM LISTVOLUME and determine if a container
volume is shown. If none is found, proceed with
RMM LISTVOLUME for all volumes with status code
X'32' until a container is identified.
2.
If RMM LISTVOLUME has been performed for all
logical volumes with status code X'32' and a container
volume has not been found, then further action is not
necessary.
3. For those logical volumes with status code X'32' that
are found to have a container volume, it is necessary
to change the container volume to blanks .
4. Using the volser identified as the container volume,
search for volumes associated with the container
volume and build RMM CHANGEVOLUME
commands for each volume. Use the command:
RMM SEARCHVOLUME VOLUME(*)
OWNER(*) LIMIT(*)
CONTAINER(container_volser)
CLIST(’RMM CV’,’
CONTAINER(“ ”) FORCE’)
5. Run the CLIST created in step 4 to perform the
change to a blank container volume for all volumes
found with the identified container volume.
Alternatively , each logical volume with status code X'32'
that has a container volume may be changed to a blank
container without building a CLIST. After using
RMM LISTVOLUME to find logical volumes with a
container volume, use the command:
RMM CHANGEVOLUME volser
CONTAINER(’ ’) FORCE
Note: Tape management systems other than DFSMSrmm
must facilitate a function to search and change the
container volume field to blanks for logical volumes with
a status code X'32' in the Status File upon completion of
the Export operation.
Status Code
33
Status Text
Exported Stacked Volume format not supported,
error XXXX
Probable Cause
Microcode level is incompatible with the
Exported Stacked Volume.
Call your service representative.
534
3494 Tape Library Operator Guide