IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 498 / 605

Table 28. Intervention-Required Conditions (continued)
Intervention-Required Condition Resolution Actions
Message OP0048
A cartridge containing invalid media has been left in
device xxx feed slot. Remove the cartridge.
Probable Cause
During a Mount operation, tape device xxx determined
that the cartridge is not of a compatible media type but
was not able to unload the cartridge. It is likely that the
cartridge has a missing or damaged media-type label, or
the media-type label is incorrect for the cartridge’s media
type.
1. Place the 3494 Tape Library in Pause mode.
2. Open the appropriate enclosure door.
3. If the cartridge is accessible, remove it.
4. If the cartridge is in a 3490E tape drive, make the
tape drive not ready by pressing the Ready switch,
press the Unload switch to unload the cartridge,
remove the cartridge, then make the tape drive ready
by pressing the Ready switch.
If the cartridge is in a 3590 B1A, E1A, or H1A tape
drive, select the Unload option in the Options
window, press Enter , then remove the cartridge.
If you cannot remove the cartridge, call your service
representative.
5. Close the enclosure door.
6. Place the 3494 Tape Library in Auto mode.
7. Inspect the cartridge’s seventh character. Install the
correct seventh character representing the media type.
See “Cartridge Tape Media-Type Labeling (3490E and
3590 Tape Drives)” on page 26 for the procedure.
8. Place the cartridge in the convenience I/O station.
Message OP0049
An invalid media volser (xxxxxx) has been ejected to
the convenience I/O station.
Probable Cause
During an Inventory or Inventory Update operation, the
media-type label of a cartridge has a media-type
character that the 3494 Tape Library does not support.
Supported media-type characters are 1 , E , J , and K .
1.
Remove the cartridge from the convenience I/O
station.
2. Inspect the cartridge’s seventh character. Install the
correct seventh character representing the media type.
See “Cartridge Tape Media-Type Labeling (3490E and
3590 Tape Drives)” on page 26.
3. Place the cartridge in the convenience I/O station.
Message OP0050
An invalid media volser (xxxxxx) has been ejected to
the high-capacity output station.
Probable Cause
During an Inventory or Inventory Update operation, the
media-type label of a cartridge has a media-type
character that the 3494 Tape Library does not support.
Supported media-type characters are 1 , E , J , and K . Also,
the convenience I/O station is either not installed, is full,
or is unavailable.
1. Place the 3494 Tape Library in Pause mode.
2. Open the appropriate enclosure door.
3. Remove the cartridge from the high-capacity facility.
4. Close the enclosure door.
5. Place the 3494 Tape Library in Auto mode.
6. Inspect the cartridge’s seventh character. Install the
correct seventh character representing the media type.
See “Cartridge Tape Media-Type Labeling (3490E and
3590 Tape Drives)” on page 26 and “Tape Cartridge
Bar Code Labels (3592 Tape Drives)” on page 30.
7. Place the cartridge in the convenience I/O station.
472
3494 Tape Library Operator Guide