IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 500 / 605

Table 28. Intervention-Required Conditions (continued)
Intervention-Required Condition Resolution Actions
Message OP0054
Volser (xxxxxx) cannot be removed from convenience
I/O station.
Probable Cause
The cartridge accessor tried several times to remove
cartridge xxxxxx from the convenience I/O station but
failed. This could be caused by a problem with the
cartridge, the I/O station, the gripper, or the alignment
of the 3494 Tape Library.
1. Remove the cartridge from the convenience I/O
station.
2. Inspect the cartridge and cell for damage.
3. Place the cartridge in the convenience I/O station.
Message OP0055
Free storage threshold has been crossed for VTS z.
Probable Cause
The available free space in VTS z has crossed the
threshold set through the Set VTS Management Policies
window on the Library Manager.
1. Insert more 3590 or 3592 cartridges into the library.
Ensure that their volsers are within the range of
stacked volumes defined for the VTS reporting the
condition.
2. The VTS Active Data window for the VTS is updated
to reflect any newly added stacked volumes on the
hour.
Message OP0056
A volser (xxxxxx) with an unknown media type has
been left in the convenience input station.
Probable Cause
The media-type label is damaged.
1.
Remove the cartridge from the convenience I/O
station.
2. Inspect the cartridge’s seventh character. Install the
correct seventh character representing the media type.
See “Cartridge Tape Media-Type Labeling (3490E and
3590 Tape Drives)” on page 26 for the procedure.
3. Place the cartridge in the convenience I/O station.
Message OP0057
A volser (xxxxxx) with an unknown media type has
been left in the high-capacity input station.
Probable Cause
The media-type label is damaged.
1. Place the 3494 Tape Library in Pause mode.
2. Open the enclosure.
3. Remove the cartridge from the high-capacity input
rack.
4. Inspect the cartridge’s seventh character. Install the
correct seventh character representing the media type.
See “Cartridge Tape Media-Type Labeling (3490E and
3590 Tape Drives)” on page 26 for the procedure.
5. Place the cartridge in the convenience I/O station.
6. Close the enclosure door.
7. Place the 3494 Tape Library in Auto mode.
Message OP0058
An invalid volser (xxxxxx) has been ejected to the
convenience I/O station.
Probable Cause
Invalid volsers contain leading or imbedded blanks or
invalid characters. Valid characters are upper case A–Z
and numerics 0–9.
1. Remove the cartridge from the convenience I/O
station.
2. Determine why the cartridge is invalid and take
corrective action.
474
3494 Tape Library Operator Guide