IBM TotalStorage 3494 Tape Library, Operator'S Manual

Page: 494 / 605

Table 28. Intervention-Required Conditions (continued)
Intervention-Required Condition Resolution Actions
Message OP0034
A mislabeled cleaner cartridge has been left in device
xxx feed slot. Remove the cartridge.
Probable Cause
During a Clean operation, tape drive xxx determined
that the cleaner cartridge is not compatible but was not
able to unload the cartridge. It is likely that the cartridge
has a missing or damaged media-type label, or the
media-type label is incorrect for the cartridge’s media
type.
1. Place the 3494 Tape Library in Pause mode.
2. Open the appropriate enclosure door.
3. If the cartridge is accessible, remove it.
4. If the cartridge is in a 3490E tape drive, make the
tape drive not ready by pressing the Ready switch,
press the Unload switch to unload the cartridge,
remove the cartridge, then make the tape drive ready
by pressing the Ready switch.
If the cartridge is in a 3590 B1A, E1A, or H1A tape
drive, select the Unload option in the Options
window, press Enter , then remove the cartridge.
If you cannot remove the cartridge, call your service
representative.
5. Close the enclosure door.
6. Place the 3494 Tape Library in Auto mode.
7. Inspect the cartridge’s seventh character. Install the
correct seventh character representing the media type.
See the tape drive Operator Guide for the procedure.
8. Place the cartridge in the convenience I/O station.
Message OP0035
A recoverable error occurred on device xxx. A service
call may be needed if the error persists.
Probable Cause
Tape device xxx recovered from a failure to load or
unload a tape cartridge.
A service call may be needed if the error persists.
Message OP0036
A mislabeled cleaner cartridge has been ejected to the
convenience I/O station.
Probable Cause
An attempt was made to a clean a tape drive, but the
cartridge was determined to be a data cartridge, not a
cleaner cartridge. One of the following conditions caused
the problem:
v The cartridge was labeled mistakenly with an external
volser that falls within the range of volsers designated
for cleaner volumes in the 3494 Tape Library.
v The ranges set in the library conflict with ranges
already in use for data cartridges.
1. Remove the cartridge from the convenience I/O
station.
2. Determine if the volser on the cartridge is included in
the ranges of volsers defined for cleaner cartridges by
selecting the Cleaner Masks option in the Commands
window on the Library Manager console.
3.
Either correct the cleaner masks or relabel the
cartridge.
468
3494 Tape Library Operator Guide