IBM 866441Y - Netfinity 5600 - 8664, Hardware Maintenance Manual

Page: 227 / 276

PCNTNW-NW-167 PCI scan specified, device not found.
Explanation: The driver cannot locate the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller is enabled. (See “PCI Slot/Device
Information” on page 35.)
If the problem persists, go to “General checkout” on page 6 to run the
diagnostic programs.
PCNTNW-NW-180 The DMA parameter is not necessary for PCI device.
Explanation: The Ethernet controller does not require a DMA setting.
Action: None necessary, message is for information only.
NDIS 2.01 (OS/2) driver messages:
This
section contains the error messages for the NDIS 2.01
(OS/2) drivers. The explanation and recommended action
are included with each message.
PCNTND-1 Unable to open the Protocol Manager.
Explanation: The NDIS stack is not configured correctly.
Action: Check and correct your configuration.
PCNTND-6 Out of memory while allocating buffers.
Explanation: The driver could not allocate the requested buffers.
Action: Check your system configuration. Edit the PROTOCOL.INI file to
reduce the number of Txbuffers and Rxbuffers specified for the driver.
PCNTND-7 A Protocol Manager device error occurred.
Explanation: The NDIS stack is not configured correctly.
Action: Check and correct your configuration.
PCNTND-8 Bad status for the Protocol Manager.
Explanation: The NDIS stack is not configured correctly in the
PROTOCOL.INI file.
Action: Check and correct your configuration.
PCNTND-9 Cannot find the PROTOCOL.INI entry.
Explanation: The NDIS stack is not configured correctly in the
PROTOCOL.INI file.
Action: Check and correct your configuration.
PCNTND-10 The Protocol Manager Input Output Control (IOCTL)
failed.
Explanation: The NDIS stack is not configured correctly in the
PROTOCOL.INI file.
Action: Check and correct your configuration.
PCNTND-11 Protocol Manager registration failed.
Explanation: The NDIS stack is not configured correctly.
Action: Check and correct your configuration.
PCNTND-15 Device not found.
Explanation: The driver cannot find an Ethernet controller in the server.
Action: Verify that the Ethernet controller is enabled. (See “PCI Slot/Device
Information” on page 35.) If the Ethernet controller is enabled, go to “General
checkout” on page 6 to run the diagnostic programs.
PCNTND-16 PCI scan specified, device not found.
Explanation: The driver cannot locate the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller is enabled. (See “PCI Slot/Device
Information” on page 35.) If the Ethernet controller is enabled, go to “General
checkout” on page 6 to run the diagnostic programs.
Netfinity 5600 - Type 8664
219