IBM 866441Y - Netfinity 5600 - 8664, Hardware Maintenance Manual

Page: 96 / 276

.4/
CD-ROM Eject/Load Button: Press this button to
eject or retract the CD-ROM tray so that you can
insert or remove a CD.
.5/
Hard Disk Status Light: Each of the hot-swap
drive bays has a Hard Disk Status light. When this
amber light is on continuously, the drive has failed.
When the light flashes slowly (one flash per
second), the drive is being rebuilt. When the light
flashes rapidly (three flashes per second), the
controller is identifying the drive.
.6/
Hard Disk Activity Light: Each of the hot-swap
drive bays has a Hard Disk Activity light. When this
green light is flashing, the drive is being accessed.
.7/
Cover Release Lever: Use this lever to release
the left-side cover on the tower model or the top
cover on the rack model.
.8/
Reset Button: Press this button to reset the server
and run the power-on self-test (POST).
.9/
Power Control Button: Press this button to
manually turn the server on or off.
Caution
The power control button on the device and the
power switch on the power supply do not turn
off the electrical current supplied to the device.
The device also might have more than one
power cord. To remove all electrical current
from the device, ensure that all power cords
are disconnected from the power source.
1
2
The server can be activated in several ways:
Ÿ
You can turn on the server by pressing the
Power Control button on the front of the
server.
Note
If you have just plugged the power cord of
the server into an electrical outlet, you will
have to wait approximately 20 seconds
before pressing the Power Control button.
88
Netfinity Server HMM