IBM 866441Y - Netfinity 5600 - 8664, Hardware Maintenance Manual

Page: 157 / 276

When you turn on the server, the POST routine assigns
the parallel port a specific port address. You can change
the parallel-port assignment by using the
Configuration/Setup Utility program. See “Devices and I/O
Ports” on page 28.
Video port:
The system board in the server has one
SVGA video port. This port is used to attach a video
monitor. The video port has a 15-pin analog connector on
the back of the server. (See “Input/output connectors and
expansion slots” on page 91 for the location of the
connector.)
1
5
11 15
The following table shows the pin-number assignments for
the video connector.
Keyboard port:
The system board has one keyboard
port. (See “Input/output connectors and expansion slots”
on page 91 for the location of the connector.)
6
4
2
1
3
5
Table 4. Video port pin-number assignments
Pin Signal
1 Red
2 Green or monochrome
3 Blue
4 Monitor ID bit 2
5 Ground
6 Ground
7 Ground
8 Ground
9
+
5 V dc
10 Ground
11 Monitor ID bit 0
12 DDC SDA
13 Horizontal synchronization (Hsync)
14 Vertical synchronization (Vsync)
15 DDC SCL
Netfinity 5600 - Type 8664
149