IBM 866441Y - Netfinity 5600 - 8664, Hardware Maintenance Manual

Page: 101 / 276

.6/
Hot-Plug PCI Expansion Slots: The server has
three hot-plug PCI expansion slots.
.7/
Attention Lights for Hot-Plug PCI Slots: Each
hot-plug PCI slot has an Attention light that is
visible from the rear of the server. An Attention
light flashes approximately once per second when it
is on. The meaning of the Attention lights is
defined by the operating system. Refer to the
operating system documentation to determine if it
supports hot-plug PCI adapters and, if so, what the
Attention lights indicate.
.8/
Non-Hot-Plug PCI Expansion Slots: The server
has two non-hot-plug PCI expansion slots.
.9/
Parallel Connector: A signal cable for a parallel
device, such as a printer, connects here.
.1ð/
SCSI Connector: External SCSI devices attach
here. For more information, see “Connecting
external options” on page 146.
.11/
Management Port C Connector: This connector
is used to attach a modem that is dedicated to
communication with the Netfinity Advanced System
Management Processor.
.12/
Video Connector: The monitor signal cable
connects here.
.13/
Universal Serial Bus 1 and 2 Connectors: You
can attach an I/O device to either of these universal
serial bus (USB) connectors. USB 2 is the
connector nearest to the edge of the server. You
need a 4-pin cable to connect a device to USB 1 or
2.
Note
If a standard (non-USB) keyboard is attached
to the keyboard port, the USB ports are
disabled while the power-on self-test (POST) is
running and no USB devices will work during
POST.
.14/
Ethernet Connector: The server has one RJ-45
Ethernet connector. This connector is for attaching
the network cable to the integrated 10BASE-T or
100BASE-TX, twisted-pair transceiver.
.15/
Mouse Connector: The mouse cable connects
here. This port sometimes is called an
auxiliary-device or pointing-device port.
.16/
Keyboard Connector: The keyboard cable
connects here.
.17/
Power Connectors: The power cords for the
power supplies connect here.
Netfinity 5600 - Type 8664
93