IBM 866441Y - Netfinity 5600 - 8664, Hardware Maintenance Manual

Page: 170 / 276

1. Turn off the server and peripheral devices and
disconnect all external cables and power cords (see
“Preparing to install options” on page 100); then
remove the cover (see “Removing the left-side cover
(tower model)” on page 103 or “Removing the cover
(rack model)” on page 104).
2. Locate the battery on the system board (see “System
board component locations” on page 166).
3. Remove adapters to allow access to the battery.
(See “Installing a hot-plug PCI adapter” on page 110
for information about installing and removing adapters
from the hot-plug PCI slots.)
4. Remove the plastic dividers between the hot-swap
PCI slots to allow access to the battery.
5. Remove the battery:
a. Use one finger to lift the battery clip over the
battery.
b. Use one finger to slightly slide the battery toward
the rear of the server. The spring mechanism
behind the battery will push it out toward you as
you slide it forward.
c. Use your thumb and index finger to pull the
battery from under the battery clip.
d. Ensure that the battery clip is touching the base
of the battery socket by pressing gently on the
clip.
6. Insert the new battery:
a. Tilt the battery so that you can insert it into the
front of the socket, under the battery clip.
b. As you slide it under the battery clip, press the
battery down into the socket.
7. Reinstall any adapters you removed. (See “Installing
a hot-plug PCI adapter” on page 110 for information
about installing and removing adapters from the
hot-plug PCI slots.)
8. Reinstall any plastic dividers that you removed.
9. Reinstall the top cover and complete the installation
(see “Completing the installation” on page 141).
162
Netfinity Server HMM