IBM 866441Y - Netfinity 5600 - 8664, Hardware Maintenance Manual

Page: 149 / 276

Completing the installation
To complete the installation, you must reinstall the cover,
reconnect all the cables that you disconnected in
“Preparing to install options” on page 100, and, for certain
options, run the Configuration/Setup Utility program.
Follow the instructions in this section.
Ÿ
If you have a tower model, continue with “Completing
the tower model installation.”
Ÿ
If you have a rack model, go to “Completing the rack
model installation” on page 144.
Completing the tower model installation:
To complete the installation for the tower model:
1. Install the left-side cover, if it was removed.
2. Install the trim bezel, if it was removed.
3. Install the server door, if it was removed.
4. Restart the server.
5. Update device records and reconfigure the server
(see “Updating device records and reconfiguring the
server” on page 60).
To install the server left-side cover:
CPU
VRM
MEMOR
Y HDD
PCI
B
US
NMI
SMI
SER
VI CE PR
OCESSOR
BU
S
NON REDUND
ANT
PO
W ER SUPPL
Y
1 2
3
A B
1 2
3
FA
N
TEMPERA
TURE
.1/
Slots
.2/
Left-side cover
a. Align the left-side cover
.2/
with the left side of
the server, about 25 mm (1 inch) from the front of
the server; place the bottom of the left-side cover
on the bottom rail of the left-side side of the
chassis.
b. Insert the tabs at the top of the cover into the
slots
.1/
at the top of the server side.
Netfinity 5600 - Type 8664
141