IBM 866441Y - Netfinity 5600 - 8664, Hardware Maintenance Manual

Page: 121 / 276

Attention
Make sure the Power light
.6/
for the hot-plug
PCI slot is off before you continue to the next
step.
4. Remove the expansion-slot cover
.1/
:
a. Rotate the adapter retention latch
.3/
counterclockwise.
b. Lift the tab
.2/
covering the top of the
expansion-slot cover
.1/
and then remove the
expansion-slot cover from the server. Store it in
a safe place for future use.
Attention
Expansion-slot covers must be installed on
all vacant slots. This maintains the
electromagnetic emissions characteristics of
the system and ensures proper cooling of
system components.
5. Refer to the documentation that comes with the
adapter for any cabling instructions. It might be
easier for you to route any cables before you install
the adapter.
6. Press on the touchpoint on the adapter retainer flap
.4/
at the end of the slot nearest the front of the
server and rotate the adapter retainer flap upward.
7. Remove the adapter from the static-protective
package.
Attention
Avoid touching the components and gold-edge
connectors on the adapter.
8. Place the adapter, component-side up, on a flat,
static-protective surface.
9. Install the adapter
.8/
:
a. Carefully grasp the adapter
.8/
by its top edge
or upper corners, and align it with the expansion
slot on the system board.
b. Press the adapter firmly into the expansion slot.
Attention
When you install an adapter in the server,
be sure that it is completely and correctly
seated in the system-board connector.
Incomplete insertion might cause damage to
the system board or the adapter.
c. Lower the tab
.2/
on the adapter guide over the
tab on the top corner of adapter. Rotate the
adapter retention latch
.3/
clockwise until it
snaps into place.
Netfinity 5600 - Type 8664
113