IBM 866441Y - Netfinity 5600 - 8664, Hardware Maintenance Manual

Page: 133 / 276

.1/
Hot-swap bays
.2/
CD-ROM drive bay
.3/
Non-hot-swap bay B
.4/
Non-hot-swap bay A
.5/
Diskette drive bay B
.6/
SCSI ID 9 bay
.7/
SCSI ID 5 bay
.8/
SCSI ID 4 bay
.9/
SCSI ID 3 bay
.1ð/
SCSI ID 1 bay
.11/
SCSI ID 0 bay
The server contains hardware that lets you replace a failed
hard disk drive without turning off the server. Therefore,
you have the advantage of continuing to operate the
system while a hard disk drive is removed or installed.
These drives are known as
hot-swappable drives. They
are also referred to as hot-swap drives.
Each hot-swap drive that you plan to install must have a
hot-swap-drive tray attached. The drive must have a
single connector attachment (SCA) connector.
Hot-swap-drive trays come with the hot-swap drives.
Ÿ
The server comes with a preinstalled 3.5-inch,
1.44 MB diskette drive and a preinstalled IDE
CD-ROM drive.
Ÿ
Bays A and B come without a device installed. These
bays are for 5.25-inch, half-high, removable-media
drives, such as tape backup drives. Bays A and B
can be combined into a single full-high bay.
Ÿ
The Netfinity 5600 server supports only one diskette
drive.
Note
The server's EMI integrity and cooling are both
protected by having bays A and B covered or
occupied. When you install a drive, save the
filler panel from the bay, in case you later remove
the drive and do not replace it with another.
Ÿ
If you are installing a device with a 50-pin connector
in one of the non-hot-swap bays (bays A–B), you
need a 68-pin to 50-pin converter. To order the
Netfinity 5600 - Type 8664
125