IBM 866441Y - Netfinity 5600 - 8664, Hardware Maintenance Manual

Page: 51 / 276

à ð
Unexpected SCSI Command Failure
Target SCSI ID: 4
SCSI CDB Sent: ð3 ðð ðð ðð ðE ðð ð7 ðð ð2 ðð
Host Adapter Status: ððh - No host adapter error
Target Status: ð2h - Check condition
Sense Key: ð2h - Not ready
+Sense Code: ð4h
+Sense Code Qualifier: ð2h
Press 'Esc' to continue.
á ñ
Performing a low-level disk format:
You can use
the Format Disk feature of the SCSISelect Utility program
to perform a low-level format on a hard disk drive.
Depending on the hard disk drive capacity, the Low-Level
Format program could take up to two hours.
When To use the Low-Level Format
program:
Use the Low-Level Format program:
Ÿ
When you are installing software that requires a
low-level format
Ÿ
When you get recurring messages from the diagnostic
tests directing you to run the Low-Level Format
program on the hard disk drive
Ÿ
As a last resort before replacing a failing hard disk
drive
Note
For information about backing up all of the files, see
the operating-system documentation.
Starting the Low-Level Format program
Attention
The Low-Level Format program erases all data and
programs.
Note
If the server has a RAID adapter installed, refer to the
RAID adapter documentation for instructions for
performing a low-level format on a hard disk drive
attached to the PCI RAID adapter.
1. If the hard disk is working, make a backup copy of all
the files and programs on the hard disk drive
2. Select Format Disk; then, follow the instructions on
the screen.
Netfinity 5600 - Type 8664
43