IBM 866441Y - Netfinity 5600 - 8664, Hardware Maintenance Manual

Page: 111 / 276

Removing the left-side cover (tower model)
Before you begin:
Read “Safety information” on page 230.
Note
The illustrations in this book are similar to your server;
details might vary.
CPU
VRM
MEMOR
Y
HDD PCI B
US
NMI
SMI
SER
VICE PR
OCESSOR
BU
S
NON REDUND
ANT
PO
W
ER SUPPL
Y
1 2 3
A B
1 2 3
FA N
TEMPERA
TURE
.1/
Cover-release latch
.2/
Cover
To remove the left-side cover of the tower model or
the top cover of the rack model:
1. If you are planning to install or remove any part other
than a hot-swap hard disk drive, hot-plug adapter,
hot-swap power supply, or hot-swap fan, turn off the
server and all attached devices and disconnect all
external cables and power cords (see “Preparing to
install options” on page 100).
2. Slide the cover-release lever
.1/
on the front of the
server to release the cover and slide the cover
.2/
toward the rear of the server about 25 mm (1 inch).
Move the top edge of the cover out from the server;
then, lift the cover off the server. Set the cover aside.
Netfinity 5600 - Type 8664
103