IBM 8285 Nways, Installation And User Manual

Page: 198 / 265

Ÿ You tried to download a file that does not exist on the host. Check that you have not misspelled the name
(blank spaces are treated as normal characters).
5. Messages:
File too big/file-too-big
.
Ÿ
You tried to download an operational code to the boot sector of the workgroup switch. Check the filetype for
the download, and check the file name of the file to be downloaded.
6. Messages: Bad file header/Cannot interpret file/invalid-file-header .
Ÿ You tried to download a file that is not downloadable. If the source file name is correct, and it was obtained by
FTP, it might have been transferred in ASCII mode instead of binary. Check the size of the downloadable file,
and compare it with the theoretical size provided by your IBM service representative. If the size is correct,
contact your IBM service representative.
7. Messages: Checksum Error/Packet error/checksum-error .
Ÿ There has been a problem during the transfer.
Download the file again.
Ÿ
A byte is corrupted in the source file.
Either get a new source (re-install the source file from your installation package), or, if it fails again, contact
your IBM service representative.
8. Messages: Flash memory failure/hardware-error .
Ÿ Try to download several times. If it always fails, contact your IBM service representative.
9. Messages: Target Blade Mismatch .
Ÿ
You tried to download FPGA picocode that is incompatible with the target module number. Check the type of
module (A4-FB100, A2-MB155 etc.) and the TFTP parameter.
Workgroup Switch cannot restart after a download inband operation is performed and TFTP-supported
services are operational.
Steps to Take:
1. Use the DOWNLOAD OUT_OF_BAND command to load the microcode that was previously active. Then restart
the workgroup switch.
2. Contact your IBM service representative.
170
IBM 8285 Nways ATM Workgroup Switch: Installation and User’s Guide