IBM 8285 Nways, Installation And User Manual

Page: 148 / 265

To save the changes made to an individual parameter, enter the parameter name in the SAVE command.
For example, if you changed the type of interface used on an ATM port, you would save this setting as
follows:
à
@
ð
8285
>
set port 1.3 enable UNI [ENTER]
Port set
8285
>
save module_port [ENTER]
8285
>
Note that if you changed configuration settings for the DEVICE or TERMINAL, these values are not
saved using the SAVE MODULE_PORT command. To save these settings, you must use the SAVE
DEVICE and SAVE TERMINAL commands.
When all your configuration changes are saved, log off the console by entering the LOGOUT command
and pressing Enter. The system prompts you when you are logged off:
à
@
ð
8285
>
logout [ENTER]
Bye
If, when logging off, you have changed workgroup switch configuration parameters but forgotten to save
them, the following message appears:
à
@
ð
8285
>
logout [ENTER]
WARNING: Save unsaved changes before logout.
The system prompt is redisplayed. You must then either save your changes (using the SAVE command)
or cancel them (using the REVERT command) before you can log off.
Note: You can log off and keep the configuration changes you last made by entering logout force .
The force parameter allows you to keep and reuse your current configuration settings until you reset or
reboot the workgroup switch. The next time you reset or reboot, these settings are lost.
120
IBM 8285 Nways ATM Workgroup Switch: Installation and User’s Guide