IBM 8285 Nways, Installation And User Manual

Page: 143 / 265

Chapter 15. Configuring SNMP Parameters
Carry out the procedures in this chapter only if you want to manage your ATM subsystem from an
SNMP workstation.
If you want to manage the ATM subsystem in an ATM Workgroup Switch from an SNMP workstation, you
may access the workgroup switch through either a Classical IP subnetwork or a LAN Emulation
subnetwork.
Procedures
SNMP Using “Classical IP Over ATM”
To manage the workgroup switch from a “Classical IP Over ATM” subnetwork, perform the following
steps:
1
Set the IP address and subnetwork mask, as described in “IP Address and Subnetwork Mask
(IP only)” on page 117, using the command:
set device ip_address
2
Set the default gateway, as described in “Default Gateway (IP & LE)” on page 117, using the
command:
set device default_gateway
3
Set the ARP server address, as described in “ARP Server (IP only)” on page 117, using the
command:
set device arp_server
4
Set the community table, as described in “Community Table (IP & LE)” on page 118, using
the command:
set community
5
Specify which alerts you want to enable, as described in “Alerts (IP & LE)” on page 118,
using the command:
set alert
6
Return to “Procedure 2: Configuring the ATM Workgroup Switch” on page 24.

Copyright IBM Corp. 1995, 1996
115