HP Fabric OS v7.0.1, Administrator'S Manual

Page: 487 / 584

Fabric OS Administrator’s Guide 449
53-1002446-01
Disabling F_Port trunking
22
Port Type State Master TI DI
-------------------------------------
36 F-port Master 36 37 36
37 F-port Slave 36 37 37
38 F-port Slave 36 37 38
39 F-port Slave 36 37 39
•
Enter the porttrunkarea
--
show trunk command to display the trunking information.
switch:admin> porttrunkarea --show trunk
Trunk Index 37: 39->0 sp: 8.000G bw: 16.000G deskew 15 MASTER
Tx: Bandwidth 16.00Gbps, Throughput 1.63Gbps (11.84%)
Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%)
Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%)
38->1 sp: 8.000G bw: 8.000G deskew 15
Tx: Bandwidth 16.00Gbps, Throughput 1.63Gbps (11.84%)
Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%)
Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%)
37->1 sp: 8.000G bw: 8.000G deskew 15
Tx: Bandwidth 16.00Gbps, Throughput 1.63Gbps (11.84%)
Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%)
Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%)
36->1 sp: 8.000G bw: 8.000G deskew 15
Tx: Bandwidth 16.00Gbps, Throughput 1.63Gbps (11.84%)
Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%)
Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%)
Disabling F_Port trunking
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the portDisable command to disable the ports that are to be removed from the trunk
area.
3. Enter the portTrunkArea
--
disable command to remove ports from the trunk area.
This command does not unassign a TA if its previously assigned Area_ID is the same address
identifier (Area_ID) of the TA unless all the ports in the trunk group are specified to be
unassigned.
switch:admin> portdisable 0-2
switch:admin> porttrunkarea --disable 0-2
Trunk index 2 disabled for ports 0, 1, and 2.
Enabling the DCC policy on a trunk area
After you assign a trunk area, the portTrunkArea CLI checks whether there are any active DCC
policies on the port with the index TA, and then issues a warning to add all the device WWNs to the
existing DCC policy with index as TA.
All DCC policies that refer to an Index that no longer exists will not be in effect.
1. Add the WWN of all the devices to the DCC policy against the TA.
2. Enter the secPolicyActivate command to activate the DCC policy.
You must enable the TA before issuing the secPolicyActivate command in order for security to
enforce the DCC policy on the trunk ports.