HP Fabric OS v7.0.1, Administrator'S Manual

Page: 301 / 584

Fabric OS Administrator’s Guide 263
53-1002446-01
Zone merging
11
Brocade Advanced Zoning is configured on the primary fabric configuration server (FCS). The
primary FCS switch makes zoning changes and other security-related changes. The primary FCS
switch also distributes zoning to all other switches in the secure fabric. All existing interfaces can
be used to administer zoning.
You must perform zone management operations from the primary FCS switch using a zone
management interface, such as Telnet or Web Tools. You can alter a zone database, provided you
are connected to the primary FCS switch.
When two secure fabrics join, the traditional zone merge does not occur. Instead, a zone database
is downloaded from the primary FCS switch of the merged secure fabric. When E_Ports are active
between two switches, the name of the FCS server and a zoning policy set version identifier are
exchanged between the switches. If the views of the two secure fabrics are the same, the fabric’s
primary FCS server downloads the zone database and security policy sets to each switch in the
fabric. If there is a view conflict, the E_Ports are segmented due to incompatible security data.
All zones should use frame-based hardware enforcement; the best way to do this is to use WWN
identification exclusively for all zoning configurations.
Zone merging
When a new switch is added to the fabric, it automatically takes on the zone configuration
information from the fabric. You can verify the zone configuration on the switch using the procedure
described in
“Viewing the configuration in the effective zone database” on page 259.
If you are adding a switch that is already configured for zoning, clear the zone configuration on that
switch before connecting it to the zoned fabric. See
“Clearing all zone configurations” on page 259
for instructions.
Adding a new fabric that has no zone configuration information to an existing fabric is very similar
to adding a new switch. All switches in the new fabric inherit the zone configuration data. If the
existing fabric has an effective zone configuration, then the same configuration becomes the
effective configuration for the new switches.
Before the new fabric can merge successfully, it must pass the following criteria:
•
Before merging
To facilitate merging, check the following before merging switches or fabrics:
-
Default Zone: The switches must adhere to the default zone merge rules, as described in
“Zone merging scenarios” on page 265.
-
Effective and defined zone configuration match: Ensure that the effective and defined
zone configurations match. If they do not match, and you merge with another switch, the
merge might be successful, but unpredictable zoning and routing behavior can occur.
•
Merging and segmentation
The fabric is checked for segmentation during power-up, when a switch is disabled or enabled,
or when a new switch is added.
The zone configuration database is stored in nonvolatile memory by the cfgSave command. All
switches in the fabric have a copy of this database. When a change is made to the defined
configuration, the switch where the changes were made must close its transaction for the
change to be propagated throughout the fabric.